When laying out the sides, use all the pieces you have to your advantage. Spacing the formers relies on the next piece that butts to it or interlocks between them.
For example, there is a bottom RC GEAR panel that will install later in the build, this panel will space the two formers perfectly. Use caution and be certain the formers are square and 90 degrees to the table.
Also be sure the position of the rear former does not cross the window.
For example, there is a bottom RC GEAR panel that will install later in the build, this panel will space the two formers perfectly. Use caution and be certain the formers are square and 90 degrees to the table.
Also be sure the position of the rear former does not cross the window.
Comment