The other day while working on the leading edge sheeting, there was time left to finish up the spoiler levers. Must say it quite enjoyable. Also stained the inside of the rear seat wing area as it will be visible from the rear seat and lower wing windows.
Announcement
Collapse
No announcement yet.
Some day it will sprout wings
Collapse
X
-
Progress continues on the scratch build Bunny Nose LK-10A with a little snag. Cardboard templates were cut and fitted for the wing stub section with the other side yet to be done. You can get to a point that you loose momentum, so a step back to see what you have done and with the help of some masking tape where it has yet to go rejuvenates the building process .6 Photos
Leave a comment:
-
With the fuselage stringers installed and turtledeck fitted the old girl has nearly doubled in girth now. The nosecone has been set and with some whittling for the tow release and forward skid mount the nosecone just needs finishing along with a lot of other parts.4 Photos
Leave a comment:
-
A dry fit of the fuselage stringers is starting to show off the graceful curves of this old lady.3 Photos
Leave a comment:
-
Some day it will sprout wings
After building two extremely scale sailplanes it's time to start what might be another. The airframe is 1/3 scale with a wing span of 199.8", as for what it will be, it follows a numerical sequence. Being in the early stages it will sprout wings someday with a 18.64" root chord and a 7.324 tip.2 PhotosTags: None
Leave a comment: